Varnish finish floors 3D
Epoxy finish for multilayer systems
It is a 100% epoxy product for solids of very low odor formulated for the decoration of floors / epoxy floors 3D, it allows to choose any drawing or decorative motif and once placed on the support it acts as self-leveling 3D, leaving some incredible finishes. It is solvent-free. High abrasion resistance, high wetting and support adhesion, resistant to heavy traffic. Very good adhesion especially to concrete supports and cement mortar. It forms a hard, abrasion-resistant film. They can be applied in high thicknesses greater than 1 cm.
| Appearance | Transparent bicomponent epoxy resin |
| Total curing | 5-7 days |
| Mix life | 25 -30 minutes 25ºC |
| Repainting | Minimum 12 hours maximum 24 hours (at 25°C) |
| Presentation | Pack 1 kg, 4 kg y 16 kg |
| Conservation | Keep away from extreme temperatures |
| Drying time | 1 day |
| Can be stepped on | 2-16 hours |
| Passaable | 24 hours |
TECHNICAL DATA
| Resistance to mortar compression | 1/0,5:350-500 Kg/cm2 |
| Flexo-traction resistance of mortar | 1/6: 175:300 Kg/cm2 |
| Adhesion (with primer) | > 30 Kg/cm2 Break the concrete |
Mixing preparation
Add the epoxy catalyst to the base and mix with the help of a mechanical stirrer at 400-500 rpm, mix until a homogeneous consistency is obtained. It is not advisable to exceed the blending time to avoid the formation of foams.
Application to trowel or roller. As it is extended it is necessary successive passes of a roller of puas to deaeaire the product and that it is totally transparent.
Add the epoxy catalyst to the base and mix with the help of a mechanical stirrer at 400-500 rpm, mix until a homogeneous consistency is obtained. It is not advisable to exceed the blending time to avoid the formation of foams.
Application to trowel or roller. As it is extended it is necessary successive passes of a roller of puas to deaeaire the product and that it is totally transparent.
Other Information
 Technical data sheet |
 Safety data sheet
|
 Transparent |
