Sealing and finishing primer.
Extra Arkil Peña is a copolymer of medium particle: it has good toughness and good brightness, so that leaves a great film, allowing the sealing of porous facings where it is about to make a Temple work with embossing, chopped Temple, striped Temple or other drawings, on plaster, etc.
This product can also be used for finishes of these same works.
|Finish||Transparent satin to semi-glossy, depending on the water to be added.|
|Viscosity||55 K.U. at 20º C|
|Coverage||12 at 14 m2/lt.|
|2 to 4 hours.|
|Thinner||Water, so it is considered fireproof. Three or four parts of water to one of Akril.|
|1, 5, and 25 Lts.|
|Conservation||Keep protected from extreme temperatures.|
It can be applied by brush, roller or spray. Facings to be applied must be clean and dry.
Do not apply at temperatures below 5 ° C or above 35 ° C.
The product supports different levels of dilution, getting different levels of sealing and/or brightness. At higher dilution (4: 1 water/Arkil) greater penetration, less sealing and less brightness. At lower dilution (2/1 water/Arkil) lower penetration, greater stamping and higher brightness.
|Technical data sheet||Safety data sheet||Whitish transparent colour|
Colours according to sample under minimal order of 400 Kgs.